Material Recommendations for HPL

… High Pressure Laminate

This chapter offers free of charge Material Recommendations for HPL-high pressure laminate materials and fixing optimisation.

Given values refer to AVG-Average Values or LEV-Lower Expected Values.

AVG – Average Value is a sum of all test results divided by number of tests.
LEV – Lower Expected Value  is a minimal breaking force for 95% of test results given by confidence level of 75% (based on ETAG 034).
Newest test results and optimisations you can see on Blick’s Vimeo Material Recommendations album
and Blick’s YouTube Playlist: Material Recommendation.

Note: Blick offers Project Recommendation and structural calculations, in which proper values are calculated and are proven by approved structural designer adequate for particular project.
Presented results are for presentation purposes only. Please contact Blick in case of use. Blick does not bears any resposibility for improper use or calculations made based on below data without previous written acceptance.

For more information about thin material application check our article: How to install achors in 10mm panels.

HPL: Recommendation for Formica 10mm

Presented recommendation is for 10mm HPL Formika with 8mm undercut anchor by Blick type BSA-S10.06.M20.
AVG Pullout values for 8mm anchor: 5502 N / 1012 lbf.
HPL represents highest pull out values considering 8 and 10mm panels.
More about at www.formica.com

AVG 8mm anchor pullout [N]

AVG 8mm anchor pullout [lbf]

HPL: Recommendation for Trespa 10mm

Presented recommendation is for 10mm HPL Trespa with 7mm undercut anchor by Blick type BSA-S10.06.M30.
AVG Pullout values for 8mm anchor: 4502 N / 1012 lbf.
HPL represents highest pull out values considering 8 and 10mm panels.
More about at www.trespa.com

AVG 7mm anchor pullout [N]

AVG 7mm anchor pullout [lbf]

HPL: Recommendation for Trespa 8mm

Presented recommendation is for 8mm HPL Trespa with 6mm undercut anchor by Blick type BSA-S10.06.M630.
AVG Pullout values for 6mm anchor: 2920 N / 656 lbf.
HPL represents highest pull out values considering 8 and 10mm panels.
More about at www.trespa.com

AVG 6mm anchor pullout [N]

AVG 6mm anchor pullout [lbf]

HPL: Recommendation for 7mm Fundermax M.Look – Fireresistant

Presented recommendation is for 7mm Fundermax M.Look with 6mm and 5mm undercut anchor by Blick type BSA-S10.06.M620.
AVG Pullout values for 6mm anchor: 900 N / 202 lbf.

AVG 6mm anchor pullout [N]

AVG 6mm anchor pullout [lbf]